Night Schedule

Here is an example of a “Night Schedule” created by some of our staff members here at CoralVue.

Create a Night Schedule

Create a Schedule and configure it with the following values:

• Type – Set it to “Flow Pattern.”
• Pattern – Set it to “Sine Wave.”
• Speed Range – Set the range from 1 to 50%.
• Cycle Duration – 00:01:00.000
• Pump Count – Set this to the desired number of pumps you want to run when this schedule is active.
  
  TIP: The Pump Count is not a dropdown field.  It is a slider.  To change the number of pumps, place your finger on the blue number and slide left or right to decrease or increase pumps.
• Pump # – Select each pump you want to add to the schedule.
  
  WARNING: You MUST select a pump.  If you leave this field blank, then your pumps will not run.  ONLY pumps assigned to a schedule will automatically run.
• Position # – Select the position you want this pump to assume when running in this schedule.
• Active Modes – Make sure that Normal mode is selected.
• Start Time – 22:00:00
• End Time – 10:00:00
• Run every N Days – Set this to 1
• Run On Days of Week – Select ALL days of the week
• Depends On – Unused
• Enable Advanced Settings – Disabled